Keysight E4981A - System:beeper[:Immediate]; System:beeper:state

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 273
Command Reference
E4981A SCPI Commands
:SYSTem:BEEPer[:IMMediate]
Syntax :SYSTem:BEEPer[:IMMediate]
Description Produces a beep sound.
If the beep sound is disabled (OFF has been specified with the
:SYSTem:BEEPer:STATe command), no beep sound is produced even if you
execute this command. (No query)
Related commands :SYSTem:BEEPer:STATe on page 273
Equivalent key
sequence
No equivalent key is available on the front panel.
:SYSTem:BEEPer:STATe
Syntax :SYSTem:BEEPer:STATe {ON|OFF|1|0}
:SYSTem:BEEPer:STATe?
Description Turns ON/OFF the beep output.
This command has the same function as the
:CALCulate1:COMParator:BEEPer[:STATe] command.
Parameters
Query response {1|0}<newline><^END>
Related commands :CALCulate1:COMParator:BEEPer[:STATe] on page 174
Equivalent key
sequence
[System] - SYSTEM CONFIG - BEEPER ENABLED - ON|OFF
Description
ON or 1 (initial value) Enables the beep sound.
OFF or 0 Disables the beep sound.