Keysight E4981A - 8. Using Handler Interface; Comparator Sorting Result Output

46 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Setting Up Measurement Conditions and Display
Setting Up Beep
3-
Setting Up Beep
Setting up conditions to make a beep sound
To turn ON/OFF the beep sound, use one of the following commands. You can
use either of these two commands since both functions are identical.
• :CALCulate1:COMParator:BEEPer[:STATe] on page 174
• :SYSTem:BEEPer:STATe on page 273
To generate the beep sound regardless of ON/OFF setting, use
:SYSTem:BEEPer[:IMMediate] on page 273. To change the tone of beep
sound from five different types of available tones, use :SYSTem:BEEPer:TONE
on page 274.
To set the conditions to make a beep sound according to the comparator
sorting result, use the following command.
• :CALCulate1:COMParator:BEEPer:CONDition on page 173
The table below shows the relationship between the settings made by the
above commands and the condition to make a beep.
Making a beep sound
To make a beep sound, use the following command:
• :SYSTem:BEEPer[:IMMediate] on page 273
Setting of
:CALCulate1:CO
MParator:BEEPe
r[:STATe] or
:SYSTem:BEEPer
:STATe
Setting of
:CALCulate1:C
OMParator:BEE
Per:CONDition
Condition to make a beep
OFF ——— Never make a beep sound
ON
FAIL
•When wrong
key operation is
performed.
•When an error,
alarm, or other
message is
output.
•When the sorting
judgment result of
the comparator is
OUT_OF_BIN, OVLD,
LOWC_OR_NC or
AUX_BIN.
PASS
•When the sorting
judgment result of
the comparator is
within BIN1 to BIN9.