Keysight E4981A - Using the Status Reporting System

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 371
Status Reporting System
Using the Status Reporting System
Using the Status Reporting System
You can manage the status report system by using the following commands in
any combination:
• *CLS on page 157
• *SRE on page 162
• *STB? on page 162
• *ESE on page 157
• *ESR? on page 158
• :STATus:PRESet on page 271
• :STATus:OPERation:ENABle on page 270
• :STATus:OPERation:CONDition? on page 269
• :STATus:OPERation[:EVENt]? on page 270
For sample programs that demonstrate the use of the commands listed above,
refer to “Waiting For Completion Of Measurement (Detecting Completion Of
Measurement)” on page 61 in
Chapter 5 or “Detecting the occurrence of an
error” on page 84 in
Chapter 8.