Keysight E4981A - Handler Interface Pin Assignment and Signals

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 47
Setting Up Measurement Conditions and Display
Saving/Recalling Instrument Setup State (Save/Recall Function)
Saving/Recalling Instrument Setup State (Save/Recall Function)
You can save/recall up to 20 instrument settings into/from the built-in
nonvolatile memory (Flash memory, 0 through 9) and external USB memory
(10 through 19).
For information on the instrument setups you can save/recall, refer to
Operation Manual, Appendix C “Initial Setting”.
Saving instrument setup state
To save the instrument setup state, use the following command.
• *SAV on page 161
• :MMEMory:STORe:STATe[:REGister] on page 229
Recalling saved instrument setup state
To recall the saved instrument setup state, use the following command.
• *RCL on page 160
• :MMEMory:LOAD:STATe[:REGister] on page 229
The ninth instrument setting corresponds to Auto Recall.
Auto recall is not executed when power is ON, by pressing the [Preset] key.