Keysight E4981A - USB Remote Control System; System Configuration

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 33
Overview of Remote Control
USB Remote Control System
USB Remote Control System
The USB (Universal Serial Bus) remote control system provides device control
via USB, which is equivalent to control via GPIB. Connection is made through
an interface in compliance with USBTMC-USB488 and USB 2.0.
USBTMC (USB Test & Measurement Class) is a protocol whose design is based
on USB for communication with a USB device, such as that via GPIB.
System configuration
The USB remote control system controls instruments that use the name “alias.”
There is no such address for GPIB connections.
Use a USB cable to connect the E4981A to an external controller (personal
computer). Figure 2-9 shows an overview of the system configuration for the
USB remote control system
Figure 2-9 Configuration of the USB remote control system
Required equipment
1. E4981A (models with USB interface port (type mini-B)).
2. External controller (personal computer with Keysight I/O Libraries Suite and
USB host port (type A)) installed.
3. Other USB-compatible devices (instruments and/or peripherals for specific
purposes).
4. USB cable for connecting the E4981A to the external controller (with type
A/4-prong male or type mini-B/5-prong male connectors, depending on
device used).
e4981aue0019
㪟㪜 㪮 㪣㪜 㪫 㪫
㪧㪘 㪚 㪢 㪘 㪩㪛
㪭㪼㪺㫋㫉㪸
㪋㪏 㪍 㪆㪍㪍 㪯 㪤
㪩㪜㪪㪜㪫
Agilent E4981A
L CUR
L POT
H POT
H CUR
UNKNOWN
Discharge test device before connecting
r10V Peak Max Output CAT I
rV Peak Max
SYNC CLK
In / Out
Trigger
Return
789
456
123
0
.
Preset
Display
Format
Meas
Setup
Recall A Recall B
Save/
Recall
System
Local/
Lock
㪚㫆㫄㫇㫌㫋㪼㫉
㪘㫃㫀㪸㫊㩷㪥㪸㫄㪼
㪘㫃㫀㪸㫊㩷㪥㪸㫄㪼
㪬㪪㪙㩷㪺㪸㪹㫃㪼
㪦㫋㪿㪼㫉㩷㪠㫅㫊㫋㫉㫌㫄㪼㫅㫋㫊