Keysight E4981A - Using the Cable Correction Function; Turning ON;OFF the Cable Correction Function; Executing LOAD Measurement in Cable Correction; Executing OPEN Measurement in Cable Correction

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 55
Preparation for Accurate Measurement (Executing Correction)
Using the Cable Correction Function
Using the Cable Correction Function
Turning ON/OFF the cable correction function
To turn ON/OFF the cable correction function, use the following command:
• :CALibration:CABLe:CORRection:STATe? on page 170
Executing LOAD measurement in cable correction
To execute LOAD measurement in cable correction, use the following
command:
• :CALibration:CABLe:CORRection:COLLect[:ACQuire]:LOAD on
page 166
Executing OPEN measurement in cable correction
To execute OPEN measurement in cable correction, use the following
command:
• :CALibration:CABLe:CORRection:COLLect[:ACQuire]:OPEN on
page 167
Executing REFerence measurement in cable correction
To execute REFerence measurement in cable correction, use the following
command:
• :CALibration:CABLe:CORRection:COLLect[:ACQuire]:REFerence
on page 168
Saving cable correction data
To save the cable correction data, use the following command:
• :CALibration:CABLe:CORRection:SAVE on page 169
Clearing cable correction data
To clear the cable correction data, use the following command:
• :CALibration:CABLe:CORRection:CLEar on page 165