Keysight E4981A - SCPI Command Table

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 307
Command Reference
SCPI Command Table
SCPI Command Table
Table 10-1 lists the E4981A SCPI commands sorted according to function
Table 10-1 SCPI command table
Function Item to Be Set Up/Executed SCPI Command
Measurement
condition
Reset :SYSTem:PRESet on page 284,*RST on page 160
Measurement
parameter setup
Primary parameter :CALCulate1:FORMat on page 188
Secondary parameter :CALCulate2:FORMat on page 191
Measurement
signal setup
Frequency :SOURce:FREQuency[:CW] on page 267
1 MHz frequency shift :SYSTem:FSHift on page 281
Level :SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitu
de] on page 268
Signal level compensation (LVL
COMP)
:SOURce:VOLTage:ALC[:STATe] on page 267
Output mode :SOURce:VOLTage:MODE on page 269
Measurement
range setup
AUTO [:SENSe][:FIMPedance]:RANGe:AUTO on page 265
Range [:SENSe][:FIMPedance]:RANGe[:UPPer] on
page 266
Measurement time
mode setup
Conventional commands for
4268A/4288A compatibility)
[:SENSe][:FIMPedance]:APERture[:MODE] on
page 252
N [:SENSe][:FIMPedance]:APERture:TIME on
page 253
Averaging setup ON/OFF [:SENSe]:AVERage[:STATe] on page 233
Number of Averaging [:SENSe]:AVERage:COUNt on page 232
Cable length setup :CALibration:CABLe[:LENGth] on page 171
Source delay setup :TRIGger[:SEQ1]:DELay on page 303
Trigger delay setup :TRIGger:SEQ2:DELay on page 306
Analog convergence waiting time setup [:SENSe]:DETector:DELay1 on page 250
[:SENSe]:DETector:DELay2 on page 250
[:SENSe]:DETector:DELay3 on page 251