204 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
E4981A SCPI Commands
10-
:DATA:POINts:BUF3
Syntax :DATA:POINts:BUF3 <numeric>
:DATA:POINts:BUF3?
Description Specifies the size of data buffer 3 in number of measurements. Executing this
command returns the pointer to the specified data buffer (the location to feed
measurement data) back to the start.
Parameters
If the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if
the upper limit of the range is exceeded) is set.
MAX or MIN can be used to specify the parameters.
Query response {numeric}<newline><^END>
Related commands :DATA:FEED:CONTrol:BUF3[:STATe] on page 199
:DATA:FEED:CONTrol[:STATe] on page 200
Equivalent key
sequence
No equivalent key is available on the front panel.
The functionality of this command is same as :DATA:POINts[:DATA] with
value of BUF3.
<numeric>
Description Number of measurements for the data buffer specified with BUF3
Range 1 to 1000
Initial value 1000
Resolution 1
To Next Page
Loading...
