Keysight E4981A - Test:scanner:eom

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 299
Command Reference
E4981A SCPI Commands
:TEST:SCANner:EOM
Syntax :TEST:SCANner:EOM {ON|OFF|1|0}
Description
This command sets the Scanner End of Measurement (EOM) signal for test purpose
and can be used to check/troubleshoot the Test pin signal of Scanner interface. (No
Query)
Parameters
Related commands :TEST:SCANner:CH? on page 298
:TEST:SCANner:INDex on page 300
:TEST:SCANner:MODE on page 301
:TEST:SCANner:TRIGger? on page 302
:TEST:SCANner:VALid? on page 302
Equivalent key
sequence
No equivalent key is available on the front panel.
When :TEST:SCANner:MODE is set to ON, the interface pin signal value
can be controlled/read by: TEST:SCAN:xxxx commands. After completing
the test, :TEST:SCANner:MODE should set to OFF so that scanner interface
pin signal is generated according to the actual measurement result.
Description
ON Sets Scanner EOM status to ON.
OFF Sets Scanner EOM status to OFF.