Keysight E4981A - Sorting Results, Counts, and Beep Output

44 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Setting Up Measurement Conditions and Display
Setting Up Display
3-
Setting Up Display
Turning ON/OFF display
To turn ON/OFF display of the measurement parameter obtained, the
measurement signal level monitored, the handler output (comparator sorting
result), the multi-correction settings, and the correction data, use the following
command.
• :DISPlay[:WINDow][:STATe] on page 215
Setting up measurement result display
You can set up the following items related to the measurement result display.
• Fixed point display
•ON/OFF
• Value of highest digit
The following table shows the commands used to set up the above items.
Selecting items displayed in instrument setup display area
To select a display page for the part that displays the instrument setup at the
right of the display (instrument setup display area), use the following
command.
• :DISPlay:PAGE on page 213
Displaying measurement result as deviation from reference value (deviation
measurement mode)
You can use the deviation measurement mode to display a relative
measurement result as deviation from the reference value instead of displaying
its absolute value. To turn ON/OFF the deviation measurement mode, use the
following commands.
• :CALCulate1:MATH:STATe on page 190
• :CALCulate2:MATH:STATe on page 193
Setup item Command
Fixed point
display
ON/OFF :DISPlay[:WINDow]:TEXT1[:DATA]:
FMSD[:STATe] on page 217
Value of highest digit :DISPlay[:WINDow]:TEXT1[:DATA]:
FMSD:DATA on page 216