Keysight E4981A - Parameters; Equivalent Key

156 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
Notational Conventions in this Command Reference
10-
The definitions of symbols used in the syntax are as follows.
<> Characters enclosed in this pair of symbols are necessary
parameters when sending a command.
[] A part enclosed in these parentheses can be omitted.
{} A part enclosed in these parentheses indicates that you must
select one of the items in this part. Individual items are
separated by a vertical bar (|).
For example, “:APER SHOR”, “:SENS:FIMP:APER:MODE LONG,” and so on are
valid for the syntax given below.
Syntax
[:SENSe][:FIMPedance]:APERture[:MODE] {SHORt|MEDium|LONG}
Parameters
A part with heading “Parameters” describes parameters necessary for sending
the command. When a parameter is a value type or a string type enclosed with
<>, its description, allowable setup range, Initial (Preset) value, and so on are
given; when a parameter is a selection type enclosed by {}, the description of
each selection item is given.
Equivalent key
A part with the heading “Equivalent key” shows the operational procedure for
the front panel keys. An equivalent key has the same effect as a certain
command.
[Key] Indicates that you press the key named Key.
[Key] - ITEM Indicates a series of key operations in which you press [Key],
select the item called ITEM (softkey or field name) on the
displayed menu using the cursor keys, and then press the
softkey.