Keysight E4981A - Source:frequency[:Cw]; Source:voltage:alc[:State]

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 267
Command Reference
E4981A SCPI Commands
:SOURce:FREQuency[:CW]
Syntax :SOURce:FREQuency[:CW] <numeric> [Hz|kHz|MHz]
:SOURce:FREQuency[:CW]?
Description Sets the measurement frequency.
Depending on this setting, the available measurement range varies (set with
the [:SENSe][:FIMPedance]:RANGe[:UPPer] command). If changing the
measurement frequency results in a conflict with the measurement range
setting, an acceptable range is automatically selected.
Parameters
Query response {120|1E3|1E6}<newline><^END>
Related commands [:SENSe][:FIMPedance]:RANGe[:UPPer] on page 266
Equivalent key
sequence
[Meas Setup] - FREQ - 120 Hz|1 kHz|1 MHz
:SOURce:VOLTage:ALC[:STATe]
Syntax :SOURce:VOLTage:ALC[:STATe] {ON|OFF|1|0}
:SOURce:VOLTage:ALC[:STATe]?
Description Determines whether to use the signal level compensation function (LVL
COMP).
Parameters
Query Response {1|0}<newline><^END>
Equivalent key
sequence
[Meas Setup] - LVL COMP- ON|OFF
Description
Range Option 001 = 120 Hz, 1kHz and 1MHz
Option 002 = 120 Hz and 1 kHz
Initial value 1 kHz
Description
ON or 1 Enables the signal level compensation function.
OFF or 0 (Initial value) Disables the signal level compensation function.