Keysight E4981A - System:communicate:gpib[:Self]:Address; System:communicate:lan[:Self]:Address

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 275
Command Reference
E4981A SCPI Commands
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess
Syntax :SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <numeric>
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess?
Description Sets the GPIB address.
Parameter
Query response {numeric}<newline><^END>
Equivalent key [System] - SYSTEM CONFIG - GPIB ADDR
:SYSTem:COMMunicate:LAN[:SELF]:ADDRess
Syntax :SYSTem:COMMunicate:LAN[:SELF]:ADDRess <String>
:SYSTem:COMMunicate:LAN[:SELF]:ADDRess?
Description Sets the static IP address.
Parameter
Query response {“string”}<newline><^END>
Equivalent key [System] - SYSTEM CONFIG - MANUAL IP ADDR - ENTER
<Numeric>
Range 0 to 30
Initial (Factory set) value 17
Resolution 1
The value of this command is not changed with *RST and :SYSTem:PRESet
and is only changed with Factory Default reset (available only through
Front Panel).
<String>
Initial (Factory set) value "192.168.1.101"
The value of this command is not changed with *RST and :SYSTem:PRESet
and is only changed with Factory Default reset (available only through
Front Panel).