Keysight E4981A - Format:border

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 223
Command Reference
E4981A SCPI Commands
:FORMat:BORDer
Syntax :FORMat:BORDer {NORMal|SWAPped}
:FORMat:BORDer?
Description When the data transfer format is set to the binary type, this command sets the
transfer order of each byte in data (byte order).
Parameter
Query response {NORM|SWAP}<newline><^END>
Related commands :FETCh? on page 220
:READ? on page 230
:DATA[:DATA] on page 208
*TRG on page 163
[:SENSe]:CORRection:DATA on page 240
[:SENSe][:FIMPedance]:CONTact1:VERify:BUF1:DATA? on page 253
[:SENSe][:FIMPedance]:CONTact1:VERify:BUF2:DATA? on page 256
Equivalent key No equivalent key is available on the front panel.
Description
NORMal (Preset value) Specifies the byte order in which transfer starts from the
byte that includes the MSB (Most Significant Bit)
SWAPped Specifies the byte order in which transfer starts from the
byte that includes the LSB (Least Significant Bit)