Keysight E4981A - Calculate1:Comparator:beeper[:State]

174 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Command Reference
E4981A SCPI Commands
10-
:CALCulate1:COMParator:BEEPer[:STATe]
Syntax :CALCulate1:COMParator:BEEPer[:STATe] {ON|OFF|1|0}
:CALCulate1:COMParator:BEEPer[:STATe]?
Description Turns ON/OFF the beep output.
If you turn off the beep output, the beep sound is not produced, regardless of
the sorting result of the comparator.
This command has the same function as the :SYSTem:BEEPer:STATe
command.
Parameters
Query response {1|0}<newline><^END>
Related commands :SYSTem:BEEPer:STATe on page 273
:CALCulate1:COMParator:BEEPer:CONDition on page 173
Equivalent key
sequence
[Meas Setup] - LIMIT TABLE - BEEP
Description
ON or 1 (initial value) Turns ON the beep output.
OFF or 0 Turns OFF the beep output.