Keysight E4981A - Page 343

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 343
Information for Replacing 4268A, 4288A with E4981A
4268, 4288A vs. E4981A SCPI Command Correspondence Table
Measurement
condition
Source delay setup :TRIG[SEQ1]:D
EL
] NA Trigger delay
only for 4288A
Trigger delay setup :TRIG:SEQ2:DE
L
] :TRIG:DEL
Analog convergence waiting time setup [:SENSe]:DETe
ctor:DELay[1-
3]
NA NA
Correction Entire correction ON/OFF NA [:SENSe]:CO
RRection[:S
TATe]
NA 4268A:
Separately set
ON/OFF for
only LOAD
4288A:
ON/OFF for
each
calibration
type.
OPEN correction ON/OFF [:SENSe]:COR
Rection:OPEN[
:STATe]
NA ]
SHORT correction ON/OFF [:SENSe]:COR
Rection:SHORt
[:STATe]
NA ]
LOAD correction ON/OFF [:SENSe]:COR
Rection:LOAD[
:STATe]
:CORR:COLL:
METH
]
OPEN correction data parameter format [:SENSe]:COR
Rection:CKIT:S
TAN1:FORMat
NA ]
SHORT correction data parameter format [:SENSe]:COR
Rection:CKIT:S
TAN2:FORMat
NA ]
LOAD standard
definition
Definition value [:SENSe]:COR
Rection:CKIT:S
TAN3:[DATA]
]]
Parameter type [:SENSe]:COR
Rection:CKIT:S
TAN3:FORMat
]]
Measurement Range on Load correction [:SENSe]:COR
Rection:COLLe
ct:LOAD:RANG
E:AUTO
NA ]
[:SENSe]:COR
Rection:COLLe
ct:STAN3:RAN
GE:AUTO
NA NA
Correction data Measurement [:SENSe]:COR
Rection:COLLe
ct[:ACQuire]
]]
Setup and read out [:SENSe]:COR
Rection:DATA
]]
Offset correction ON/OFF [:SENSe]:COR
Rection:OFFSe
t[:STATe]
NA ]
Correction Offset correction data setup [:SENSe]:COR
Rection:OFFSe
t:DATA
NA ]
Table B-1 At-a-glance SCPI command correspondence between 4268A, 4288A, and E4981A (by function)
Function Item to Be Set Up/Executed SCPI Command Note
E4981A 4268A 4288A