Keysight E4981A - Page 344

344 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Information for Replacing 4268A, 4288A with E4981A
4268, 4288A vs. E4981A SCPI Command Correspondence Table
-
Scanner (multi
correction)
ON/OFF [:SENSe]:COR
Rection:MULTi
ple:[:STATe]
]]
Channel setup [:SENSe]:COR
Rection:MULTi
ple:CHANnel
]]
LOAD standard correction method setup [:SENSe]:COR
Rection:MULTi
ple:CKIT:STAN
3[:STATe]
]]
Cable correction Correction Data OPEN :CALibration:C
ABLe:CORRect
ion:COLLect[:A
CQuire]:OPEN
NA NA
LOAD :CALibration:C
ABLe:CORRect
ion:COLLect[:A
CQuire]:LOAD
NA NA
0m standard :CALibration:C
ABLe:CORRect
ion:COLLect[:A
CQuire]:REFer
ence
NA NA
Correction coefficient clear :CALibration:C
ABLe:CORRect
ion:CLEar
NA NA
Correction coefficient calculation and save :CALibration:C
ABLe:CORRect
ion:SAVE
NA NA
Read ON/OFF on correction function :CALibration:C
ABLe:CORRect
ion:STATe?
NA NA
Trigger Triggering *TRG ]]
:TRIGger[:SEQ
1][:IMMediate
]
:TRIGger[:SE
Quence1][:I
MMediate]
:TRIGger[:SE
Quence1][:I
MMedaite]
Trigger mode setup :TRIGger[:SEQ
1]:SOURce
:TRIGger[:SE
Quence1]:S
OURce
:TRIGger[:SE
Quence1]:S
OURce
Trigger delay time setup :TRIGger:SEQ2
:DELay
:TRIGger:SE
Quence2:DE
Lay
:TRIGger[:SE
Quence1]:D
ELay
Trigger system Resets :ABORt ]]
Initiates :INITiate[:IMM
ediate]
]]
Continuous activation ON/OFF :INITiate:CONT
inuous
]]
BNC External Trigger slope :TRIGger[:SEQ
1]:SLOPe
NA NA
Table B-1 At-a-glance SCPI command correspondence between 4268A, 4288A, and E4981A (by function)
Function Item to Be Set Up/Executed SCPI Command Note
E4981A 4268A 4288A