Keysight E4981A - Page 345

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 345
Information for Replacing 4268A, 4288A with E4981A
4268, 4288A vs. E4981A SCPI Command Correspondence Table
Measurement Data Data transfer format
setup
Binary/ASCII :FORMat[:DAT
A]
]]4288A: These
functions are
affected to
input/ouput of
correction
data(:CORR:DA
TA)
Binary data byte order :FORMat:BORD
e
NA NA
ASCII long format :FORMat:ASCii
:LONG
NA NA
Data readout Measurement result :FETCh? ]]
:READ? ]]
Data buffer :DATA[:DATA]
?
{BUF1|BUF2|B
UF3}
]]BUF3 is not for
4268A
Measurement signal monitor result :DATA[:DATA]
?
{IMON|VMON}
]]
Measurement data Data buffer setup Feeding target parameter :DATA:FEED[:S
OURce]
{BUF1|BUF2},
{CALC1|CALC2
}
:DATA:FEED :DATA:FEED
:DATA:FEED:B
UF[1-2]
{CALCulate1,
CALCulate2}
Control (feed/not feed) :DATA:FEED:C
ONTrol
[:STATe]
{BUF1|BUF2|B
UF3},[ALWays|
NEVer]
:DATA:FEED:
CONTrol
]
:DATA:FEED:C
ONTrol:BUF[1-
3][:STATe]
[ALWays|NEVe
r]
Buffer size :DATA:POINts[:
DATA]
{BUF1|BUF2|B
Uf3}
:DATA:POINt
s
]
:DATA:POINts:
BUF[1-3]
Table B-1 At-a-glance SCPI command correspondence between 4268A, 4288A, and E4981A (by function)
Function Item to Be Set Up/Executed SCPI Command Note
E4981A 4268A 4288A