Keysight E4981A - Page 309

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 309
Command Reference
SCPI Command Table
Trigger Triggering *TRG on page 163, :TRIGger[:SEQ1][:IMMediate] on
page 304
Trigger mode setup :TRIGger[:SEQ1]:SLOPe on page 304
Trigger delay time setup :TRIGger:SEQ2:DELay on page 306
Trigger system Resets :ABORt on page 164
Initiates :INITiate[:IMMediate] on page 228
Continuous activation ON/OFF :INITiate:CONTinuous on page 227
BNC External Trigger slope :TRIGger[:SEQ1]:SLOPe on page 304
Measurement
Data
Data transfer
format setup
Binary/ASCII :FORMat[:DATA] on page 225
Binary data byte order :FORMat:BORDer on page 223
ASCII long format :FORMat:ASCii:LONG on page 222
Data readout Measurement result :FETCh? on page 220, :READ? on page 230
Data buffer :DATA[:DATA] on page 208
Measurement signal monitor result :DATA[:DATA] on page 208
Data buffer setup Feeding target parameter :DATA:FEED[:SOURce] on page 201,
:DATA:FEED:BUF1 on page 195, :DATA:FEED:BUF2 on
page 196
Control (feed/not feed) :DATA:FEED:CONTrol[:STATe] on page 200,
:DATA:FEED:CONTrol:BUF1[:STATe] on page 197,
:DATA:FEED:CONTrol:BUF2[:STATe] on page 198,
:DATA:FEED:CONTrol:BUF3[:STATe] on page 199
Buffer size :DATA:POINts[:DATA] on page 205,
:DATA:POINts:BUF1 on page 202,
:DATA:POINts:BUF2 on page 203,
:DATA:POINts:BUF3 on page 204
Table 10-1 SCPI command table
Function Item to Be Set Up/Executed SCPI Command