Lexmark Optra W810 - Page 119

Diagnostic Information 2-11
4023-001
Replace Toner To
Continue
The toner cartridge is
almost empty.
Inform customer that they
need to replace the toner
cartridge. See operator
manual. If you cannot
reset, go to
“Toner Feed
Service Check” on
page 2-35
.
Replace PC Kit To
Continue
The PC kit is almost
empty.
Inform customer that they
need to replace the PC kit.
See operator manual.
Staples Empty The printer finishing
device is out of staples,
or the staple unit is not
installed.
Install new staples. Check
the connection between
the stapler unit and the
finisher stapler connector.
Replace the staple unit if
necessary.
Staples Low The printer finishing
device is low on staples.
Install new staples. Check
the connection between
the stapler unit and the
finisher stapler connector.
Replace the staple unit if
necessary.
Tray 1 Missing
Tray 2 Missing
Tray 3 Missing
Tray 4 Missing
Tray 5 Missing
An input tray is missing
from the printer.
Check the tray (cassette
set sensor and actuators)
and connectors.
• Tray 1–PC6
• Tray 2–PC3
• Tray 3–PC3
• Tray 4–SLIDE
Replace as necessary.
Replace the printer main
engine board (PWB-A) if
necessary.
Message Description Action