Diagnostic Aids 3-23
4023-001
– Resetting Tray X
Page Counter
– Menu returns to Reset Tray Count menu.
5. Select [All Trays]
– Resetting All
– Tray Counters
– Menu returns to Reset Tray Count menu.
Note: Pressing Return takes you back to the Reset Tray Count
menu without resetting any tray counts.
Setting Configuration ID
The configuration ID is used to communicate characteristics of
certain areas of the printer that cannot be determined by the
hardware sensors. Reset the configuration ID when the engine card
is replaced.
1. Enter the Diagnostic mode. See “Diagnostics Mode” on
page 3-1.
2. Select [PRINTER SETUP].
3. Select [Configuration ID].
– The left-most digit blinks. The blinking indicates which digit is
ready for editing.
– The following message displays:
– Configuration ID
=123456*
4. Press Menu> or Menu< until the value you want displays.
5. Press Select to move to the next digit.
6. After entering the page count, press Select and move to after
the final digit and press Select.
– Configuration ID is validated. Invalid ID–”Invalid ID” is
momentarily displayed on Line 2 and ID is displayed. Valid
ID–ID is stored in NVRAM and printer automatically PORs to
activate the new setting.
Note: The printer PORs into normal mode (not diagnostics mode). If
a configuration ID is not set:
• The panel posts “Check Config ID” message.
To Next Page
Loading...
