1048 Matrix ETERNITY NE System Manual
• SMPP Client System ID: Enter the ID you want the Server to use to authenticate the Client. A maximum
of 16 characters, including all ASCII characters are allowed.
• SMPP Client Password: Enter the password you want the Server to use to authenticate the Client. To
avoid unauthorized access, make sure the password is strong and is kept confidential. The Password can
be of maximum of 9 characters, including all ASCII characters are allowed.
Make sure you:
• Do not assign the same SMPP Client System ID and Password to multiple SMPP Clients.
• Configure the same SMPP Client System ID and Password in the SMPP Client. This ID is sent to the
Server in the connection request made by the Client.
• Mobile Port: Select the Mobile Port using which the SMS is to be sent from/to the SMPP Client. SARVAM
UCS supports a maximum of 2 Mobile ports
153
.
Make sure you do not assign the same Mobile Port to multiple SMPP Clients.
• Debug: If you want to monitor the events and processes of the SMPP Client, for troubleshooting and
identifying faults and errors, select the Debug check box. The debug messages are sent to the remote
Syslog Server. For detailed instructions, for configuring the Destination Port, Syslog Server IP Address and
Port, see “System Debug”.
Viewing SMPP Server Status
• Login as System Engineer.
• Under Advanced Settings, click SMS Gateway.
• Click Status.
• The following parameters are displayed for each SMPP Client registered with SARVAM UCS:
• System ID: This is the ID received in the SMPP Client’s connection request.
• Status: This displays any one of the following:
153. Depends on the model you have. Please refer the Appendix for an overview of the system resources and maximum expansion
capacity.
Status Description
Not Connected
When the SMPP Server does not receive any request from the
SMPP Client.
To Next Page
