Matrix ETERNITY NE System Manual 181
Configuring Matrix SPARSH VP330
SPARSH VP330 is the proprietary Extended IP Phone with graphical touch-screen user interface, supplied by
Matrix. To know the list of featured supported by Matrix SPARSH VP330, refer to “SARVAM UCS Features
supported in Terminals”.
For detailed product information and operation instructions, refer to the SPARSH VP330 User Guide.
To be able to use SPARSH VP330 as SIP Extension, you must configure the following:
• SIP Extension General Parameters, see“Configuring SIP Extension General Parameters”.
• SIP Extension Settings, see “Configuring Matrix Extended Phone Settings using Jeeves”.
Configuring Matrix Extended Phone Settings using Jeeves
You can register three Matrix Extended Phones/Soft Clients at three different locations as a single SIP Extension.
You can connect the same or different types of Extended Phones/Soft Clients —SPARSH VP248, SPARSH VP310,
SPARSH VP510, SPARSH VP330, Matrix Extended SPARSH VP710, Matrix VARTA UC Clients or or MATRIX
VARTA WIN200 Desktop UC Client — at each location. In this case we assume that SPARSH VP330 is connected
at Location 1, 2 and 3.
If you have connected SPARSH VP248 refer to “Configuring Matrix SPARSH VP248”.
If you have connected SPARSH VP310 at any of the locations, refer to “Configuring Matrix SPARSH VP310”.
If you have connected SPARSH VP510 at any of the locations, refer to “Configuring Matrix SPARSH VP510”.
If you have connected Extended SPARSH VP710 at any of the locations, refer to “Configuring Matrix Extended
SPARSH VP710”.
If you have registered Matrix VARTA ADR100 and VARTA AMP100 Mobile UC Clients in any of the locations, refer
to “Configuring Matrix VARTA ADR100/AMP100 UC Clients”.
If you have registered MATRIX VARTA WIN200 UC Client in any of the locations, refer to “Configuring MATRIX
VARTA WIN200 UC Client”.
If you want to use more than one SPARSH VP330 Phones as a SIP Extension, configure their settings as Location
1, Location 2 and Location 3.
To Next Page
Loading...
