Matrix Telecom ETERNITY NE - Incoming CLI Modification

Matrix ETERNITY NE System Manual 919
Incoming CLI Modification
For PBX users in countries, where the Calling Line Identification (CLI) received must be suitably modified before it
can be used to dial out the number, SARVAM UCS offers the feature ‘Incoming CLI Modification’.
The Incoming CLI received with the Country or Area Code, or both. However, the dialing pattern of the public
network may require the received CLI to be prefixed with additional digits, to dial out the same number. Or the
dialing pattern of the public network may require the CLI to be stripped off the prefixed digits to dial out the same
number.
With the feature ‘Incoming CLI Modification’ configured, SARVAM UCS detects whether the incoming CLI is a local
number, a national, or an international number. It modifies the incoming CLI accordingly, by adding or stripping off
the prefixed digits so that the number can be dialed out as per the dialing pattern supported by the public network.
The modified CLI is presented to the extension phones and is stored in the “Call Logs”, and SMDR (see “Station
Message Detail Recording (SMDR)”). Extension users can call a number in the Call Logs without modifying the CLI
manually.
How it works
• Incoming CLI Modification parameters must be configured in the system considering the dialing pattern
supported by the local public network.
• Accordingly, SARVAM UCS matches the CLI received with the configured parameters.
• It detects whether it is an international, national or local number.
• It modifies the CLI according to the Modification parameters configured.
• It presents the modified CLI to the extension; stores the modified CLI in the SMDR and in the Call Logs of
the extension.
• When the received CLI is dialed out by the extension user from Call Log, SARVAM UCS dials out the
same number.
How to configure
For this feature to work, you must configure Incoming CLI Modification parameters in the “System Parameters” of
SARVAM UCS. To do this,
• Login as System Engineer.
• Under Advanced Settings, click System Parameters.
• On the System Parameters page, click Incoming CLI Modification to expand.