Matrix ETERNITY NE System Manual 87
CHAPTER 4
Configuring SARVAM UCS
SARVAM UCS can be configured using the following tools:
• A web-based graphic user interface (GUI), called Jeeves - SARVAM UCS SOHO Application
• A telephone (specific parameters only)
Each of these is explained in detail, later in this chapter.
SARVAM UCS can be configured at two levels: System Engineer and System Administrator. A distinct set of
features and facilities can be configured at each of these levels. SARVAM UCS can be configured both, on site and
from a remote location without its functioning being affected.
System Configuration using the Web-based GUI
ETERNITY NENX provides a Graphic User Interface (GUI), Jeeves, the proprietary web-based configuration
software of Matrix. It is an HTTP server built into the ETERNITY NENX.
Jeeves allows system configuration at two levels: System Engineer and System Administrator. Both these levels
are protected by SE and SA password respectively. These passwords can be changed using Jeeves only. A distinct
set of features and facilities can be configured at each of these levels.
It is possible to configure SARVAM UCS from any location using Jeeves. You can use Jeeves to configure
the system On-site (where it is installed) and Off-site, from a remote location.
System Engineer Mode
At the System Engineer level, the entire system configuration can be changed to match user requirements and
preferences. To be able to do this, the System Engineer must enter the System Engineer (SE) configuration mode,
by logging into Jeeves as System Engineer.
Access to the SE mode is protected by means of a password, referred throughout this document as the SE
Password. Four persons can simultaneously login and change the system settings from the SE mode.
To be able to access Jeeves,
• the Ethernet Port of ETERNITY NENX must be connected with a stand-alone PC or in a LAN.
• a web-browser, either Internet Explorer 7 or later or Mozilla Firefox 3.5.1 or later, must be installed on the
PC.
To Next Page
Loading...
