928 Matrix ETERNITY NE System Manual
Last Number Redial
The system redials the last number string (external/internal) dialed from an extension. By default the system stores
only the external numbers in the Last Number Redial List. If you want the system to store internal call in this list,
make sure you enable the Store Internal Calls in Redial Call Log check box in the “System Parameters”.
How it works
• Extension A dials the feature access code for ‘Redial’.
• If Extension A is a SLT, the system dials the last external number dialed from Extension A using the same
trunk access code used for dialing that number.
• If Extension A is an Extended IP Phone, last 16 numbers dialed by Extension A are displayed on the
phone’s LCD.
• Extension A may select the number to be dialed out. The system will dial out this number using the same
trunk access code used for dialing the external number.
If Extension A has ‘Dynamic Lock’ set and uses Redial feature, the system will check for Toll Control as per
the Lock Level set for Extension A before dialing out the number.
How to configure
No particular configuration is required for this feature to work. Redial is included in the Basic Features allowed to all
extensions by default in their “Class of Service (CoS)”. So, all extensions can use this feature.
How to use
For Extended IP Phone Users
• Press Redial Key.
Or
•Dial 7
A List of last 16 numbers dialed by you will appear on your phone’s display.
• Scroll to select the desired number.
• Press Enter key.
• The system dials out the selected number.
For SLT Users
• Lift Handset
•Dial 7
• The system dials out the number last dialed from your extension.
To Next Page
Loading...
