Matrix ETERNITY NE System Manual 1039
Selective Port Access
SARVAM UCS supports different extension and trunk port types. In the Selective Port Access feature, each port
type is assigned a Port Access Code. Extension users can access a particular port by dialing the Port Access Code
assigned to the Port and its Port Number.
How it works
• Extension user A wants to access a particular Mobile port, Mobile Port 1 to make a call. Extension A must
dial the Selective Port Access Feature Code, followed by the Port Type Code for Mobile ports and then dial
the Port Number.
• By default, the following access codes are assigned to each Port Type:
Here, Extension A must dial 69-25-01, where 69 is the feature code for Selective Trunk Access, 25 is the
port access code for the Mobile Port, and 01 is the number of the Mobile Port which A wants to access.
Similarly, if Extension A wants to access SIP Extension 10, A must dial 69-34-10.
How to configure
To be able to use Selective Port Access, extension users must have this feature enabled in their “Class of Service
(CoS)” for the Day and Night/Break time, as required. See “Basic Settings” for instructions on configuring CoS for
the different extension port types.
Port Type Port Type Code
Port Number
a
a.The number of ports mentioned here are for ETERNITY NENXIP50. For details regarding the num-
ber of ports supported for ETERNITY NENX312/ETERNITY NENX416, see “Technical Specifica-
tions of ETERNITY NENX”.
SLT 01 01 to 2
CO 03 01 to 04
Mobile 25 01 to 02
SIP Trunk 26 01 to 08
SIP Extension 34 01 to 50
Virtual Extensions 36 01 to 20
To Next Page
