Matrix ETERNITY NE System Manual 1131
• Toggle Day/Night mode through 'Set Day/Night Mode' key: When this check box is enabled, you can
switch to Day Mode (Working Hrs) or Night Mode (Non-Working Hrs) on pressing the DSS Key. For more
details, see “Day Night Mode”. Default: disabled.
• Replace '+' from CLI: The GSM network presents the calling party number with prefix '+' to the called
party. SARVAM UCS allows you to remove '+' and replace it with an appropriate number string as required.
To do this, you must enable Replace '+' from CLI by selecting this check box.
You may also configure the number string with which ‘+’ is to be replaced in the CLI in the Replace '+'
from CLI with the number string field. Enter the number string with which you want to replace '+'
received as prefix of calling party number.
If you keep the number string field blank, SARVAM UCS will remove '+' sign from the CLI of calling party
and present the remaining digits on the CLI of the Called Party.
For example:
The number string +919327237228 is received as CLI.
If ‘00’ is configured as the replace string, the CLI number would become 00919327237228
If no replacement string is configured (i.e. left blank), the CLI number would be presented as
919327237228.
• Disconnect Built-In Auto Attendant Call, when Dialed Number is busy: When this check box is
enabled, the Built-In Auto Attendant call will be disconnected if the landing extension is busy. The Built-In
Auto Attendant call will not be routed to the Operator. Default: disabled.
• Disconnect Built-In Auto Attendant call, when Dialed Number is not responding: When this check
box is enabled the system disconnects the Built-In Auto Attendant call if there is no reply from the landing
destination extension. The Built-In Auto Attendant call will not be routed to the Operator. Default: disabled.
• Disconnect Built-In Auto Attendant call, when caller does not Dial any digit: When this check box is
enabled, the system will disconnect the Built-In Auto Attendant call if the caller fails to dial a digit within the
First Digit Wait Timer. The Built-In Auto Attendant call will not be routed to the Operator. Default: disabled.
• If the Extension creating 3 party conference, disconnects during Conference: You can select either
to Transfer the call or Disconnect other parties, If the Extension creating 3 party conference,
disconnects during Conference.
• If you select to Transfer the call, the 3-party conference is converted into a two-way speech between
the other two parties.
• If you select to Disconnect other parties, all the parties involved in the 3-party conference are
disconnected.
See “Conference-3 Party” for more details.
• Play Beep when Conference/Dial-in Conference begins: This is a common check box for two features
of SARVAM UCS: “Conference-Multiparty” and “Conference Dial-In”. When this check box is enabled,
• the system plays beeps to the other participants in a Dial-In Conference when a new participant joins in
(i.e. dials in to an on-going Dial-In Conference)
To Next Page
