108 Matrix ETERNITY NE System Manual
• This page displays only the extension ports that are available in the system and the number of ports
you have defined as Number of Ports Used in the Pre-requisites page.
• In the case of SIP Extensions, the number you configure as Extension Number will be considered as
the SIP ID.
• You may configure the desired extension by clicking the respective link on this page.
• If you have finished assigning numbers and names, click Submit.
To assign the extension numbers and names all over again, click Clear Extn No.
To default all the feature access codes and extension numbers, click Default.
• Reassign Feature Access Codes, if required. The new access code may be a single digit or a sequence of
a maximum of 6 digits. Digits 0 to 9, # and * are allowed.
• Click Submit.
If you assign the same Access Code to more than one feature, Jeeves will pop up a ‘Total Conflict’
message and ask you to resolve the conflicting codes. It will not allow you to submit until you have
resolved the conflict.
To Next Page
Loading...
