Matrix Telecom ETERNITY NE - Page 1275

Matrix ETERNITY NE System Manual 1265
To debug a single port, define the Start and End Port numbers as the same.
•In System Debug, select Enable to start Port debug.
• Click Submit.
I/O Debug
• Select the Apply check box to enable the I/O debug.
• Select the Port Type for which you want to debug I/O communication:
•CO-SLT
• Mobile
•In Start Port, enter the number of the selected Port Type from which the system should start debugging.
•In End Port, enter the number of the selected Port Type after which the system should end debugging.
If you want to debug a range of ports, configure the starting and ending port numbers in the Start Port and
End Port.
To debug a single port, define the Start and End Port numbers as the same.
•In System Debug, select Enable to start I/O debug.
• Click Submit.