Matrix ETERNITY NE System Manual 173
• If the Extended IP phone is in the same network (LAN) as SARVAM UCS, select Use Ethernet IP
Address as Registrar Server Address.
• If the Extended IP phone is in the Global Network and SARVAM UCS is connected to Internet over
Mobile WAN, select Use Mobile Port IP Address as Registrar Server Address
• If the Extended IP Phone is connected in the Global Network and SARVAM UCS is located behind
a NAT Router, and STUN is programmed, select Use Router/STUN's IP Address as Registrar
Server Address.
• Make sure the Router’s Public IP Address is configured in the Network Parameters.
• If Dynamic DNS is configured in the Network Parameters, select Use Dynamic DNS Host Name as
Registrar Server Address.
• If you want SARVAM UCS to assign Registrar Server Address automatically, select Automatic as
Registrar Server Address.
• By default, Use Ethernet IP Address is selected as the Registrar Server IP Address.
• To set the call progress tone generation standards of the country where the SPARSH VP310 is installed,
select the Call Progress Tone - Region. Default: Region 1.
See “Call Progress Tones” to know more.
• To display the Date and Time of the country where the SPARSH VP310 is installed, select the Date and
Time - Region. Default: India.
• If you want to enable Daylight Saving Time (DST) on the phone, set Apply DST? to Yes. Default: No.
The Daylight Saving Time convention followed in the country/region you selected will be automatically
applied. The SPARSH VP310 will change its date and time settings according to the DST convention of the
selected country/region.
• Select the CO CLIP Pattern for the SPARSH VP310. This is the type of Calling Line Presentation on the
phone for incoming calls from trunks. You can select any of these options:
• Name Only (only the name of the caller will be displayed).
• Number Only (only the number of the caller will be displayed).
• Number + Name (both the name and the number of the caller will be displayed).
Default: Number + Name.
• Select the Language for the SPARSH VP310. Default: English.
SARVAM UCS provides language support for English, French, German, Spanish, Portuguese, and Italian
on the SPARSH VP310. When you select any of these languages, all the prompts and command strings
will appear in the selected language.
• SIP Extension users can change the language by accessing and navigating through the phone menu.
• The SA can change the Language by logging into the SA Jeeves.
• Select a Ringer Mode for the phone from the four options:
• Ring immediately (it rings immediately as a fresh calls lands on the phone).
To Next Page
Loading...
