Matrix ETERNITY NE System Manual 193
• Select a Ringer Mode for the phone from the four options:
• Ring immediately (it rings immediately as a fresh calls lands on the phone).
• Ring if idle (rings only if the phone is idle).
• Ring after delay (if the call is still not answered).
•Silent.
Default: Ring Immediate.
• If you have selected Ring after a delay as Ringer Mode, set the Ring Delay Timer (sec), if required, to the
desired value.
The Ring Delay Timer is the time in seconds the system waits on receiving a call before ringing on the
phone. The range of this timer is 0 to 99 seconds. Default: 10 seconds.
• If you want to enable Ringer Auto Acknowledge mode, set the Acknowledge Timer (sec) to the desired
value.
The Ringer Auto Acknowledge mode determines when to stop the ring on the phone. There are two
options for Ringer Auto Acknowledge:
• Stop only when the call is answered.
• Stop after a delay.
To stop the ring on the phone after a delay, the Acknowledge Timer must be configured. The range of this
timer is 01 to 99 seconds. Default: 00 seconds.
To stop the ring only when the Call is answered or manually acknowledged, the Acknowledge Timer must
be set to '00'.
• To assign the Ring Destination for the SPARSH VP510, select the desired destination for Play Ring on.
You may choose
• Speakerphone: The ring will be played on the Speakerphone.
• Headset: The ring will be played on the Headset.
Default: Speakerphone.
When you select the Headset as the destination, make sure that you set the ‘Headset Connected?’
parameter to Yes and connect a Headset to the IP Phone.
• Set the Ringer Volume to the desired level, from 0 to 7, according to your preference. Default: 4.
You can also set the Ringer Tune. For detailed instructions, refer to the EON510_SPARSH VP510 User
Guide.
• To increase/decrease the volume of outgoing speech (Transmit Gain) on the handset of the SPARSH
VP510, set the Handset Transmit Volume Level to the desired level, from 0 to 7. Default: 4.
• To increase/decrease the volume of incoming speech (Receive Gain) on the handset of the SPARSH
VP510, set the Handset Receive Volume Level to the desired level, from 0 to 7. Default: 4.
• To increase/decrease the volume of outgoing speech (Transmit Gain) on the headset of the SPARSH
VP510, set the Headset Transmit Volume Level to the desired level, from 0 to 7. Default: 4.
• To increase/decrease the volume of outgoing speech (Receive Gain) on the headset of the SPARSH
VP510, set the Headset Receive Volume Level to the desired level, from 0 to 7. Default: 4.
To Next Page
Loading...
