Matrix ETERNITY NE System Manual 267
• Authentication Password: Enter the Authentication Password for the SIP Extension.
Authentication Password is the password to be used by the VoIP module’s Registrar Server to
authenticate the SIP messages received from this SIP Extension. All ASCII characters (except
Percentage %, Hash #, Equal to =, Plus +, And &, Backslash \, Less than <, Greater than >,
Apostrophe ’ , Double Quote " and Space) and digits 0 to 9 are allowed. Default: Blank.
Authentication Password is the password to be used by the VoIP module’s Registrar Server to
authenticate the SIP messages received from this SIP Extension.
To avoid unauthorized access, we recommend you to change the password regularly. Make sure it
is strong and is kept confidential. The password must:
• be of minimum 8 characters and can be a maximum of 12 characters.
• include at least one upper-case, one lower-case, one number and one special character.
To provide additional security, when the authentication fails for 10 times consecutively due to wrong
Authentication ID / Authentication Password, the system will blacklist the IP Address and Port for
registration of this SIP Extension. However, you can remove the IP Address from the Black List IP
Address table manually. See “Black List IP Address - SIP Extensions” for more details. This activity
will be logged in the “System Activity Log”.
You may also choose to configure simple Authentication Password, if required. However, it is
recommended not to do so. For more details, see “Force Complex SIP/HTTP Authentication
Password” under “Security Settings”.
• Select Location: Always displays Location 1 as the Open SIP Phone can be registered at Location
1 only for Auto Provisioning.
• Location Name: Enter the name that you want the system to display for the location you selected.
• Registrar Server Address: Select the appropriate Registrar Server Address to register the device
with the SIP Registrar of SARVAM UCS, according to your installation scenario.
• Click Submit. The window closes and the details you configured will be displayed on the Device
Management page.
• Reboot: Click this button to reboot the phone remotely.
The phone will reboot only if it supports remote reboot.
• Click Clear All Assigned Entries, to clear all the assignments.
• Click Clear All Entries, to clear all the entries on the page.
To Next Page
