Matrix ETERNITY NE System Manual 577
However, the same access code can be used for features in different call phases. For example, '4' is the default
feature access code for DND Override (Routing Phase), Call Pick-Up-Group (Dial Phase) and Barge-In (Blocked
Phase).
Similarly, Extension and Logical Group Codes too must be unique and should not match with any of the features
invoked in the 'Dial' phase.
How to configure
SARVAM UCS provides default Access Codes for extensions, logical groups—department and trunk groups—and
features.
It also provides country-specific default Access Codes which are applied automatically when you select the Region
to configure the system.
The default Access Codes for India are presented in the table below. The default Access Codes table also indicates
the call phase in which each feature is invoked.
Feature
Access
Code
Call Phases
Dial Routing Blocked Placed
Matured
2-Way
Matured
3-Way
Enter SE Programming Mode 1#91 Y Y
Enter SA Programming Mode 1#92 Y Y
Abbreviated Dialing 8 Y Y
Account Code by Name 1059 Y Y
Account Code by Number 1058 Y Y
Alarm 161 Y Y
Alarm Voice-guided 163
Auto Call Back Set 2 Y Y
Auto Call Back Cancel 102 Y Y
Auto Redial Set 17 Y Y
Auto Redial Cancel 1070 Y Y
Barge-In 4 Y
Blind Transfer to Voicemail 1078 Y
Call Chaining 1050 Y
Call Cost Display 1075 Y
Call Forward 13 Y Y
Call Forward - When Not Registered *13 Y
Call Park 115 Y
Call Park Retrieve 116 Y Y
Call Pick Up-Selective 12 Y Y
Call Pickup - Group 4 Y Y
To Next Page
Loading...
