EasyManua.ls Logo

Matrix Telecom ETERNITY NE - Page 672

Matrix Telecom ETERNITY NE
1370 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
662 Matrix ETERNITY NE System Manual
The Pulse Rate Type applied (duration and cost) is divided into two parts for each time zone:
First unit.
Additional units.
Number of Units is derived from the pulse rate at the time of the call and duration of the call. System
acquires the pulse rate type and call duration with the help of in-built RTC.
Total Units = First Unit + Additional Unit.
If the call duration is less than the pulse rate of the first unit then additional unit is zero.
Call Units = (Call duration in seconds) (Pulse rate in seconds).
If the duration of the call is less than or equal to one unit,
Cost of Call = Cost of First Unit + Service Charge as applied.
If the duration of the call is more than one unit,
Cost of Call = [Cost of First Unit + (Number of Additional units x Cost for Additional units)] + Service
Charge as applied.
The system applies the rates as configured in the Normal Pulse Rate Table for all the days, except when it
detects a day configured in the Discounted Pulse Rate Schedule. These are special days when special
tariffs are offered.
For the days configured in the Discounted Pulse Rate Schedule as special days, the system checks the
duration and cost of the First unit and the Additional units configured in the Discounted Pulse Rate Table.
SARVAM UCS uses the Cost of the Call for SMDR. This cost is deducted from the Call Budget (Amount), if allotted
to the trunk and also from the Call Budget, if assigned to the extension users.
The logic for call cost calculation is explained by following example:
A Outgoing Call is made on trunk, CO-1.
On CO-1, Call Cost Calculation is configured as follows:
Call Cost Calculation Pulse Rate option = 1
Call Cost Calculation Schedule
Time Zone 1 = Start Time: 00:00, End Time: 22:00
Time Zone 2 = Start Time: 22:01, End Time: 23:59
Area Code Table is configured as:
Index
Area
Code
Name
Ignore
Digit
Count
Pulse Rate
Type for
Pulse Rate
Option - 1
Pulse Rate
Type for
Pulse Rate
Option - 2
Pulse Rate
Type for
Pulse Rate
Option - 3
Pulse Rate
Type for
Pulse Rate
Option - 4
001 26 Local 03 06 09 10
002 09 Mobile 05 03 07 08

Table of Contents

Related product manuals