EasyManuals Logo

Oracle ZFS Storage Appliance User Manual

Oracle ZFS Storage Appliance
650 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #627 background imageLoading...
Page #627 background image
Configuring ZFS Storage Appliance Networking for an Active-Active Configuration
1.
Configure the IPMP interface on Head 1.
Log on to the BUI of Head 1 and navigate to Configuration > Network.
Click the plus icon next to Interfaces. The Network Interface dialogue box opens.
Complete the dialogue box as follows:
Enter a meaningful name for the IPMP network interface.
Verify that Enable Interface is checked.
Verify that Allow Administration is checked.
Verify that Use IPv4 Protocol is checked.
Verify that the Configure with menu selection is Static Address List.
Click the plus sign next to the empty box three times, so that four empty boxes are
displayed.
In each empty box, enter one of the IP addresses reserved for the InfiniBand connections
with its respective /24 netmask designation. As a best practice, do not use consecutive IP
addresses from the block, but rather every other one (for example, all odd or all even).
Verify that Use IPv6 Protocol is not checked.
Check the IP MultiPathing Group box.
Check the boxes next to the interfaces corresponding to datalinks ibp0 and ibp3.
Verify that each of the two interfaces are set to Active and click Apply.
From Configuration > Network, click Routing.
Click on the Multihoming model corresponding to Adaptive.
2.
Configure the IPMP interface on Head 2.
Log on to the BUI of Head 2 and navigate to Configuration > Network.
Click the plus icon next to Interfaces. The Network Interface dialogue box opens.
Complete the dialogue box as follows:
Enter a meaningful name for the IPMP network interface.
Verify that Enable Interface is checked.
Verify that Allow Administration is checked.
Verify that Use IPv4 Protocol is checked.
Verify that the Configure with menu selection is Static Address List.
Click the plus sign next to the empty box three times, so that four empty boxes are
displayed.
In each empty box, enter one of the remaining four IP addresses reserved for the
InfiniBand connections with its respective /24 netmask designation. These should be the
ones not used on Head 1.
Verify that Use IPv6 Protocol is not checked.
Integration 627

Table of Contents

Other manuals for Oracle ZFS Storage Appliance

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oracle ZFS Storage Appliance and is the answer not in the manual?

Oracle ZFS Storage Appliance Specifications

General IconGeneral
Connectivity10GbE, 40GbE, InfiniBand, Fibre Channel
ProtocolsNFS, SMB, iSCSI, Fibre Channel, HTTP
Operating SystemOracle Solaris
Data Protectionsnapshots, clones, remote replication
Data ReductionInline compression, deduplication
High AvailabilityRedundant hardware components (controllers, power supplies, fans). Automatic failover between controllers. Hot-swappable drives and components. Cluster configurations for increased availability and scalability.
Management InterfaceWeb-based GUI, CLI, REST API
Storage TypeHybrid (SSD + HDD), All-Flash
Storage CapacityUp to several petabytes
EncryptionAES-256 encryption at rest

Related product manuals