Panasonic HMWIN - Using the integrated FTP server; FTP settings

Parameter Description
Note: When enabled, this option may cause high latency if the proxy server does not
immediately terminate old requests thus saturating connection sockets. This is often the case
with 3G connections.
Enable
compression
Compresses data to reduce download times. Default = disabled.
CAUTION: enabling this option could causes excessive CPU overhead.
Time
Settings
Used by the client to adapt the widget time stamp information.
FTP settings
Parameter Description
Port FTP communication port
Time settings
Parameter Description
Use Widget
Defaults
Displays time information according to the widget settings.
Local Time Translates all timestamps in the project into the computer local time where the client is
installed.
Global Time Translates all timestamps in the project into UTC format.
Server Time Translates all timestamps in the project into the same used by HMI device/server in order
to show the same time.
Important: Make sure you set the HMI RTC correct time zone and DST options.
Transferring files to a remote HMIdevice
You can upload and download files to and from a remote HMI device using two dedicated actions. These actions can only
be used from a remote HMWIN Client and access remote files via FTP.
Important: Enable FTP support and give all necessary user rights to the folders used to transfer files.
See "Remote Client actions" on page134.
See "Remote Client variables" on page85.
HMWIN Studio |User Manual| v206 (2017-06-30) | EN| © 2014-2017 Panasonic Electric Works Europe AG
155
11 Using the Client application