Automatic offline node detection
When a device is not answering to communication requests, it is de-activated. The HMI device stops sending requests to
this device. After three seconds, the HMI device sends a single command to check if device is available, if so the
communication is restarted, otherwise it is disabled for another timeout interval.
Default settings can be modified in Protocol editor.
Note: Not all protocols support this feature.
Parameter Description
Enable Offline
Algorithm
Enables offline management for the protocol
Offline Retry
Timeout
Interval in seconds for the retry cycle after a device has been deactivated. Range:
1–86.400 seconds (24h).
HMWIN Studio |User Manual| v206 (2017-06-30) | EN| © 2014-2017 Panasonic Electric Works Europe AG
209
19 Offline node management
To Next Page
Loading...
