R&S SMA100B - Page 159

Avionic standards
R&S
®
SMA100B
159User Manual 1178.3834.02 ─ 09
This dialog comprises COM/ID settings related to the ILS localizer component of
the ILS signal.
Settings
COM/ID State..............................................................................................................159
Code............................................................................................................................159
Frequency................................................................................................................... 159
Period..........................................................................................................................159
Depth...........................................................................................................................159
Time Schema.............................................................................................................. 160
Dot Length...................................................................................................................160
Dash Length................................................................................................................160
Symbol Space.............................................................................................................160
Letter Space................................................................................................................160
COM/ID State
Enables/disables the COM/ID signal.
See also Chapter D, "Morse code settings", on page 784.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid[:STATe] on page 614
Code
Sets the coding of the COM/ID signal by the international short name of the airport
(e.g. MUC for the Munich airport).
The COM/ID tone is sent according to the selected code, see Chapter D, "Morse code
settings", on page 784.
If no coding is set, the COM/ID tone is sent uncoded (key down).
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid:CODE on page 611
Frequency
Sets the frequency of the COM/ID signal.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid:FREQuency on page 612
Period
Sets the period of the COM/ID signal.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid:PERiod on page 613
Depth
Sets the AM modulation depth of the COM/ID signal.
Note: The sum of Sum of Depth and COM/ID > Depth must be smaller than 100 %.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:COMid:DEPTh on page 612
ILS configuration and settings