R&S SMA100B - Page 611

Remote control commands
R&S
®
SMA100B
611User Manual 1178.3834.02 ─ 09
EXT|INT,EXT
An external modulation source is used, additional to the internal
modulation source.
The external signal is input at the Ext connector.
*RST: INT
Example: See Example "Configure and generate an ILS glide slope signal"
on page 594.
Manual operation: See "EXT AM" on page 146
[:SOURce<hw>]:ILS[:GS|GSLope]:ULOBe[:FREQuency]
<Frequency>
Parameters:
<Frequency> float
Range: 60 to 120
Increment: 0.03
*RST: 90
Example: See Example "Configure and generate an ILS glide slope signal"
on page 594.
Manual operation: See "Up Frequency" on page 148
[:SOURce<hw>]:ILS:LOCalizer:COMid:CODE <Code>
Sets the coding of the COM/ID signal by the international short name of the airport
(e.g. MUC for the Munich airport).
The COM/ID tone is sent according to the selected code, see Chapter D, "Morse code
settings", on page 784.
If no coding is set, the COM/ID tone is sent uncoded (key down).
Parameters:
<Code> string
Example: See Example "Configure and generate an ILS localizer signal"
on page 595.
Manual operation: See "Code" on page 159
[:SOURce<hw>]:ILS:LOCalizer:COMid:DASH <Dash>
Sets the length of a Morse code dash.
Parameters:
<Dash> float
Range: 0.05 to 1
Increment: 1E-4
*RST: 0.3
SOURce subsystem