R&S SMA100B - Page 167

Avionic standards
R&S
®
SMA100B
167User Manual 1178.3834.02 ─ 09
Settings
State............................................................................................................................167
Set To Default..............................................................................................................167
Save/Recall.................................................................................................................167
State
Activates the avionic standard.
Activation of the standard deactivates a previously active avionic standard. The
"VOR/ILS > Carrier Frequency" setting is applied automatically to the RF Frequency
and displayed in the status bar.
Remote command:
<subsystem>:STATe on page 599
Set To Default
Calls the default settings. The values of the main parameters are listed in the following
table.
Standard Parameter Value
VOR/ILS/ADF State Not affected by "Set to default"
VOR Carrier Frequency Mode User Defined
Carrier Frequency 108.000000 MHz
ILS ILS Component Glide Slope (GS)
ILS GS > Carrier Frequency Mode User Defined
ILS GS > Carrier Frequency 334.700000 MHz
ADF Carrier Frequency 190.000 kHz
Remote command:
<subsystem>:PRESet on page 597
Save/Recall
Accesses the "Save/Recall" dialog, that is the standard instrument function for saving
and recalling the complete dialog-related settings in a file. The provided navigation
possibilities in the dialog are self-explanatory.
The settings are saved in a file with predefined extension. You can define the filename
and the directory, in that you want to save the file.
Remote command:
<subsystem>:SETTing:CATalog on page 598
<subsystem>:SETTing:DELete on page 598
<subsystem>:SETTing:LOAD on page 598
<subsystem>:SETTing:STORe on page 599
ADF configuration and settings