R&S SMA100B - Page 701

Remote control commands
R&S
®
SMA100B
701User Manual 1178.3834.02 ─ 09
[:SOURce<hw>]:SWEep:POWer:DWELl <Dwell>
Sets the dwell time for a level sweep step.
Parameters:
<Dwell> float
Range: 0.001 to 100
Increment: 100E-6
*RST: 0.01
Example: See Example "Setup an RF frequency or power sweep"
on page 697.
Manual operation: See "Dwell Time" on page 192
[:SOURce<hw>]:SWEep:GENeration
<SweepType>
Selects frequency sweep type.
Parameters:
<SweepType> STEPped | ANALog
STEPped
Performs a frequency sweep.
ANALog
Performs a continuous analog frequency sweep (ramp),
synchronized with the sweep time [:SOURce<hw>]:SWEep[:
FREQuency]:TIME.
*RST: STEPped
Example: See Example "Setup an RF frequency or power sweep"
on page 697.
Manual operation: See "Sweep Type" on page 188
[:SOURce<hw>]:SWEep:POWer:MODE <Mode>
Sets the cycle mode for the level sweep.
Parameters:
<Mode> AUTO | MANual | STEP
AUTO
Each trigger triggers exactly one complete sweep.
MANual
The trigger system is not active. You can trigger every step indi-
vidually with the command [:SOURce<hw>]:POWer:MANual.
The level value increases at each step by the value that you
define with [:SOURce<hw>]:POWer:STEP[:INCRement].
Values directly entered with the command [:SOURce<hw>]:
POWer:MANual are not taken into account.
SOURce subsystem