7D-28 TRANSFER BOX
26) Place a tightening washer (63) on the bearing, making sure
that the bevelling points towards the screw part of the bearing.
20) Remove front traction casing (65) once again and dismount
front bearing ring (68).
21) Place the assembly washer (69), calculated before, in the
casing (65).
22) Sink ring (68) once more into the casing.
23) Take out main shaft installation (39) and speedometer ca-
sing (37) both of which had been previously placed to carry
out the axial adjustment of the main shaft.
65
68
69
39
24) Fit the ball bearings to the double traction casing - this
supports the front bearing - and fix it with its clip.
25) Fit the two oil seals, the first with its closing lip pointing
inwards, the second pointing outwards.
62
63
37
To Next Page
Loading...
Need help?
General