System extension numbe
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
6-5
Initial operation
6.8 System extension number
After initial operation and nationalisation, enter the extension number of the system (without
DDI number and console code) or, depending on the configuration, the tie-trunk number for
Hicom 300 on the system telephone with the internal extension number 11, Figure 7-2.
The system extension number is assigned by the network provider or the Telecom
administration authority.
No system extension number may be entered in the case of point-to-multipoint operation or tie-
trunk calls to Hicom 300 (depending on the configuration).
Example:
Terminal number: 98008
National number: 2302 (prefix without 0)
International number: 49 (national code)
Figure 6-2 Starting "System administration"
Figure 6-3 Entering system extension number
Password access code
"System administration"
31994
oder
Enter code for "System
administration"
Observe display! page
through to "all data?
"
and confirm
*95
Observe display: page
through to "ISDN
parameters" and
"System ext. number"
and confirm
As of here, follow prompts
on display.
Requirement
: "System administration" started
Ex-
pert mode: code 192
To Next Page
Loading...
Need help?
General