Station attributes
Programming guide
A31003-K16-X001-3-7620
,
07/99
10-24
Hicom 100 E Version 2.1, Service manual
10.5.1.12 Station names
Each extension can be assigned a name which then appears on the system telephone’s
display.
An optiset (E) memory telephone is necessary to enter station names.
Example
: ext. 11 is to be called "CO"
10.5.2 Doorphone setup
10.5.2.1 Setting up an entrance telephone (up to SW 2.0.1+)
An entrance telephone can be connected to a free a/b extension port. The number of the
entrance telephone extension is programmed for this purpose.
The entrance telephone must be connected via a door opener adapter if the receiving extension
for the doorbell and the door opener features are to be used.
F
+ Scroll to the next station Group 1, station 3: -
G
* Change input Group 1, station 3:
H
14 Secretary telephone is ext. 14 Group 1, station 3: 14
J
<OK> Confirm input Group 1, station 3: 14
K
<F8> Return to Start menu System administration
Members can be deleted from an executive-secretary group by pressing the F3 key under
points C and H.
Input sequence Meaning Display
A 1 3 2 (up to 2.0.1+)
1 3 1 2 (as of 2.0.2)
Name for ext. 11
(scroll through ext. 12–74 using "+"
and "–" or call directly with "#")
Ext. 11: -
B*
Change input Ext. 11:
CCO
Name for ext.11 = CO Ext. 11: CO
D<OK>
Confirm input Ext. 11: CO
E
<F8> Return to Start menu System administration
An existing extension name can be deleted by pressing the F3 key under point C.
Input sequence Meaning Display
To Next Page
Loading...
Need help?
General