Siemens Hicom 112 User Manual

Call management (CM)
Initial operation
A31003-K16-X001-3-7620
,
07/99
6-14
Hicom 100 E Version 2.1, Service manual
Figure 6-7 ISDN intercept day/night
If an intercept position has not been entered, intercepted calls are allocated to the extension
which is assigned to the respective line according to the call allocation scheme (B-
channel=line).
The central intercept console (CDM 16 19) may only be configured in the case of
QSig.
Incoming calls are not signalled if there is a fault at the intercept console (only U
P0/E
extension).
You must enter a call forwarding command to an extensions in the call destination list
of the intercept console in order to guarantee a signal. The call forwarding timeout
for this list should be set to 15 rings so that calls are not forwarded when the intercept
console is functioning properly.
Ext.
11
Ext.
12
Entry
15 13
15 17
--
ISDN intercept during the day/at night (example)
Night
Entry
15 14 15 18
Ext.
11
--
ISDN connection 1
B-channel 2
Day
ISDN connection 1
B-channel 2
Ln.
2
Ext.
14
Ln.
2
Entry
Entry
Intercept console
Intercept console
Call allocation
Call allocation
Call Management
Call Management
15 193
15 194

Siemens Hicom 112 Specifications

General

Brand	Siemens
Model	Hicom 112
Category	Telephone
Language	English