Siemens Hicom 112 User Manual

Networking (Hicom 112/118 only)
Initial operation
A31003-K16-X001-3-7620
,
07/99
6-16
Hicom 100 E Version 2.1, Service manual
6.10.7 Digit repetition (menu 16 16)
Defines whether the dialled route code is automatically repeated. If digit repetition is
deactivated, only one route code per route can be programmed. Digit repetition must be
activated if several route codes are to be programmed, i.e. it prefixes the next extension number
dialled (only to be set up if Hicom 100E is networked with a main PBX which involves a shared
extension number plan).
6.10.8 Route seizure (menu 16 17)
This setting can be used to assign each route a cyclic or linear seizure sequence for the lines
of this route.
6.10.9 Error messages for network settings
The messages shown below may appear in the display of your system telephone with the
internal extension number 11 or 12. These messages are directly related to the network
settings:
Setting Message Remarks
Activate automatic line
seizure
Collision with 1612
route assignment
Not all lines configured in route 1
Collision with 1616
digit repetition
Digit repetition activated
(note all 4 routes)
Assign route other than
1 to line
Collision with 1611
auto. line seizure
Automatic line seizure is activated
Program route code
Collision with 1616
digit repetition
Digit repetition is deactivated
Activate digit repetition
Collision with 1611
auto. line seizure
Automatic line seizure is activated
Deactivate digit repeti-
tion
Collision with 224
route X, pos. X
More than one route code is assi-
gned
Assign codes
Collision with 224
route code
Collision with one of the route codes
entered
Collision with
int. extension number
Collision with one of the internal ex-
tension numbers
Table 6-2 Error messages for network settings

Siemens Hicom 112 Specifications

General

Brand	Siemens
Model	Hicom 112
Category	Telephone
Language	English