System setting
A31003-K16-X001-3-7620, 07/99
Hicom 100 E Version 2.1, Service manual
10-65
Programming guide
10.7.13 Codes
10.7.13.1 Substitute code for *
Since DP terminals cannot transmit "*", a substitute code of up to 2 digits is needed to activate
services. The default substitute code is "75".
This code can be changed (on the basis of the remaining code plan).
Example
: changing the substitute code for "*" to "78"
10.7.13.2 Substitute code for #
Since DP terminals cannot transmit "#", you need a substitute code of up to 2 digits to activate
services. The default substitute code is "76".
This code can be changed (on the basis of the remaining code plan).
Example
: change the substitute code for "#" to "79"
Input sequence Meaning Display
A2 2 1
Substitute codes for * Code: 75
B*
Change input Code
C78
Select substitute code 78 Code: 78
D<OK>
Confirm input Code: 78
E
<F8> Return to Start menu System administration
The code can be deleted by pressing the F3 key under point C.
Input sequence Meaning Display
A2 2 2
Substitute code for # Code: 76
B*
Change input Code
C79
Select substitute code 79 Code: 79
D<OK>
Confirm input Code: 79
E
<F8> Return to Start menu System administration
The code can be deleted by pressing the F3 key under point C.
To Next Page
Loading...
