Station attributes
Programming guide
A31003-K16-X001-3-7620
,
07/99
10-56
Hicom 100 E Version 2.1, Service manual
10.6.9.4 Defining intercept, incomplete DDI number
If an external ISDN caller dials an incomplete DDI number, this call is automatically forwarded
to the intercept console after approx. 20 seconds. This intercept feature can be deactivated by
appropriate programming, so that an external ISDN caller hears the "busy" tone (after approx.
20 seconds in this case). The definition applies to the entire system.
Example
: programming intercept override, incomplete DDI number.
10.6.9.5 Defining intercept, recall (as of SW version 2.0.2)
A recall request for an extension can be automatically forwarded to the intercept console if the
extension is busy or if there is no answer after a set period of time.
Example
: programming intercept console, recall.
Input sequence Meaning Display
A 1 5 1 5 4
Intercept, incomplete DDI no. Intercept: yes
B*
Change input Intercept:
C0
Select intercept override Intercept: no
D<OK>
Confirm input Intercept: no
E
<F8> Return to Start menu System administration
Intercept, incomplete DDI number can be reactivated by entering "1" under point C.
Input sequence Meaning Display
A 1 5 1 5 5
Intercept, recall Intercept: no
B*
Change input Intercept:
C1
Select intercept Intercept: yes
D<OK>
Confirm input Intercept: yes
E
<F8> Return to Start menu System administration
The intercept feature can be reactivated by entering "0" under point C.
To Next Page
Loading...
Need help?
General