Station attributes
Programming guide
A31003-K16-X001-3-7620
,
07/99
10-38
Hicom 100 E Version 2.1, Service manual
Example
: locked telephones are to be authorised to dial the numbers entered in the allowed
numbers list 1.
10.5.4.16 Dialling signal transmission mode (as of SW version 2.0.2)
The trunk line is initially seized if an outgoing external call in "step-by-step" mode is subject to
toll restriction. Dialling is interrupted and the trunk line is released if the extension is not
authorised for the numbers in question.
In "block-by-block" mode, the trunk line is only seized if the extension is authorised to dial the
number in question.
Example
: activate "block-by-block" mode
Input sequence Meaning Display
A1 4 6
Code lock COS: outward restricted
B+*
Change input Class of service:
C2
Enter allowed numbers list 1 COS: allowed nos. list 1
D<OK>
Confirm input COS: allowed nos. list 1
E<F8>
Return to Start menu System administration
A class of service <0> to <4> can be assigned by entering a value (<0>–<14>) under point C.
Input sequence Meaning Display
A1 4 7
Dialling signal transmission Mode: per digit
B+*
Change input Mode:
C1
Activate block-by-block mode Mode: en-bloc
D<OK>
Confirm input Mode: en-bloc
E<F8>
Return to Start menu System administration
"Step-by-step" mode can be reactivated by entering "0" under point C.
To Next Page
Loading...
Need help?
General